29 / 84
industrial heat tracing solutions
EN-RaychemNGC30UIT2Programming-AR-H5818602/16
3.3.2 MAIN STATUS WINDOW
The main status window displays the status of all circuits that have been setup. For each circuit,
the main window displays:
Fig. 3.7 Main window with circuit status
Ckt# Circuit number
ID Identification tag for the Circuit
°C or °F The control temperature
SetPt Desired maintain temperature
DB Dead Band
Amps Heater current amperes
G.F. Heater ground-fault current
Status Relay (heater on, off or trip) and communication status
Color Coding of Main Window
The data in the °F/°C, Amps, and G.F. columns are displayed in color to identify their current state.
Green When heater is energized (status On), within Normal range of setup
parameters
Red In Alarm condition
Orange (°F/°C only) - Temperature not within setpoint + dead band range
Alarm Relay Status
Green No alarm
Red In Alarm condition
IMPORTANT: A Configuration Spreadsheet has been developed to assist in the collection of
specific circuit details. This spreadsheet is located in Appendix F.
To Next Page
Loading...
