Pentair raychem ngc-30/uit2 - Status | Voltage Window; Status | PLI Window

47 / 84
industrial heat tracing solutions
EN-RaychemNGC30UIT2Programming-AR-H5818602/16
• Next Relay Switch Field -The time (in seconds) until the EMR or SSR changes state. This value
counts down to zero for each on or off cycle.
• Relay State Field - Current state (off or on) of the EMR or SSR assigned to this Circuit.
3.3.18 STATUS | VOLTAGE WINDOW
The Status | Voltage window displays the measured line voltage from the NGC-30-CRM/CRMS.
Fig. 3.24 Status | Voltage window
3.3.19 STATUS | PLI WINDOW
This window displays information regarding the update times for a PLI system when the heater is
off for the selected circuit.
Fig. 3.25 Status | PLI Window