Pentair raychem ngc-30/uit2 - Page 68

68 / 84
industrial heat tracing solutions
EN-RaychemNGC30UIT2Programming-AR-H5818602/16
The System|Maint. window provides the following controls:
• Clear Events List Action Button - Clears all Events and Alarms history.
IMPORTANT: By clearing the event, all the Events and Alarms history information for all Circuits is
lost. If the program exit is chosen, heaters are no longer monitored.
Calibrate Display Action Button - starts program to calibrate the screen
Exit NGC-UIT2 Action Button
Allows user to exit Raychem NGC-30 program. This ends the monitoring of all Circuits.
IMPORTANT: Make sure you disable the Watch Dog timer located on the side of the NGC-UIT2.
Otherwise, the program will continually attempt to restart the NGC-UIT2 program.
IMPORTANT: Qualified Pentair Industrial Heat Tracing Solutions Personnel Only. It is
recommended that only Pentair Industrial Heat Tracing Solutions personnel exit the NGC-UIT2
program.