IC-KP2-2HB17-2V1D
Product Description
2014-02
11
4Product Description
4.1 Product family
The brand name, IDENTControl, represents a complete identification system. The system
consists of an IDENTControl Compact unit with bus interface, inductive R/W heads (125 kHz
and 13.56 MHz), R/W heads with electromagnetic coupling (UHF with 868 MHz) and
accompanying code, and read/write tag in many different designs. The IDENTControl Compact
can be connected to other identification systems.
The system is equally well suited for use in the switching cabinet and for field use in IP67. The
interface to the controlling fieldbus is integrated into the enclosure and all connections are
implemented as plugs. This enables simple installation and quick, correct replacement in case
of device failure. The consistent EMC design (metal enclosure, grounding, shielded wires)
offers a high degree of noise immunity.
4.1.1 R/W heads
There are different R/W heads available for the IDENTControl Compact in different designs.
You can connect inductive R/W heads (125 kHz and 13.56 MHz) or R/W heads with
electromagnetic coupling (UHF with 868 MHz) depending on your particular application.
4.1.2 Read Only Tags/Read/Write Tags
Read only / read/write tag 125 kHz (inductive)
A wide range of read only and read/write tag designs are available for this frequency range,
from a 3 mm thin glass tube to a transponder 50 mm in diameter. Read/write tags are available
for temperatures up to 300 °C (max. 5 min) in chemical-resistant housings for installation in
metal and in degree of protection IP68/IP69K. IPC02-... read only tags offer 40-bit read only
codes. IPC03-... read/write tags have a 928-bit freely programmable memory bank and an
unmodifiable 32-bit read only code. You can define 40-bit read only codes with IPC11-... read
only tags. You can use these as permanent read only codes or continually redefine them.
Read/write tag 13.56 MHz (inductive)
Read/write tags in this frequency range save larger quantities of data and offer a considerably
higher reading speed than read/write tags of the 125 kHz system. IQH-* and IQH1-* read/write
heads from Pepperl+Fuchs are compatible with most existing read/write tags that comply with
standard ISO 15693. With the IQH2-* read/write heads you can use read/write tags that comply
with standard ISO 14443A.
The 13.56 MHz technology even allows smart labels (read/write tags in the form of adhesive
labels with printed barcode). Currently available read/write tags have a memory capacity of
64 bits of read only code and a maximum 2 KB of programmable memory.
Data carrier 868 MHz (UHF)
Data carriers in this frequency range can be passive as well as active (with battery) and use a
specially-shaped rod antenna as the resonance element. The passive transponders can be
produced very cheaply and have a range of several meters.
As material handling and the automotive sector requires ranges of 1 to 5 meters, this system
represents a low-cost alternative to microwave systems, particularly because of its low
transponder costs. The high carrier frequency supports large data volumes and extremely short
read times.
To Next Page
Loading...