AS-Interface
Commissioning Tools and Accessories
Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
Issue date - 21.12.2005
90
9 Commissioning Tools and Accessories
The Windows based software "AS-i Control Tools" is designed to make the comis-
sionning of the AS-i/PROFIBUS gateway so easy as possible.
The software communicates with the AS-i/PROFIBUS gateway using a PROFI-
BUS DP master simulator DP V1.
9.1 Windows Software AS-i Control Tools
The Windows software "AS-i-Control-Tools" enables you to configure the AS-i cir-
cuit in a very comfortable way.
1. For this purpose plug in a Master Simulator DP V1 or a serial PROFIBUS Mas-
terto the D-SUB-connector of the AS-i/PROFIBUS gateway and connect the de-
vice with a fully covered cable to the serial interface of your PC.
2. Start the AS-i-Control-Tools.
3. Call the command Master | New.
To Next Page
Loading...
