Perkins 1204-E44TA - Diesel Particulate Filter Temperature Is Low (if Equipped)

To Next Page

To Previous Page

i06155916

Diesel Particulate Filter

Temperature Is Low

(If Equipped)

This procedure is only applicable to engines that

have a Diesel Particulate Filter (DPF) installed.

The Electronic Control Module (ECM) monitors the

temperature at the intake of the Diesel Particulate

Filter (DPF). The ECM activates the following code

when the conditions are met.

Complete the procedure in the order in which the

steps are listed.

Table 64

Diagnostic Trouble Codes for Diesel Particulate Filter Temperature Is Low

J1939

Code

PDL Code Code Description

(code descriptions may vary)

Comments

3242-17

E1014 (1)

Particulate Trap Intake Gas Temperature : Low - least

severe (1)

The temperature at the intake of the DPF is below the

trip point that is calculated by the ECM. The trip point

varies depending on engine operating conditions.

The code is logged. The code remains active until elec-

trical power to the ECM is cycled.

3242-18

E1014 (2)

Particulate Trap Intake Gas Temperature : Low - moder-

ate severity (2)

The temperature sensor is not correctly installed.

Engine power is derated 30%. The code is logged. The

code remains active until electrical power to the ECM is

cycled.

130 UENR4469-36

Symptom Troubleshooting

Related product manuals