(Table 246, contd)
Troubleshooting Test Steps
Values Results
3. Inspect the Connector Terminals
Note: The ECM connectors cannot be repaired. If damage is
found on an ECM connector, the harness must be replaced.
A. Visually inspect each terminal in the connector. Verify that the
terminals are not damaged. Verify that the terminals are correctly
aligned in the connector and verify that the terminals are correctly
located in the connector.
Terminals are
aligned and
undamaged
Result: The terminals of the connector are damaged.
Repair: Repair the terminals and/or replace the terminals,
as required.
Use the electronic service tool to clear all logged diagnostic
codes and then verify that the repair eliminates the fault.
Result: The terminals are OK.
Proceed to Test Step 4.
Illustration 189 g01802454
A typical example of the lock wedge.
(1) Lock wedge
UENR4469-36 515
Service
Copyright of Perkins Engine Company Limited. NOT FOR REPRINTING OR RESALE
To Next Page
Loading...
