Input
11 - 9
Seam section 0
All values entered in this seam section are valid for all other seam sections in
the seam program, unless they are altered in the individual seam sections.
● Call up the stitch length input menu and enter the stitch length "2.2", see Chapter 9.06
Entering the stitch length.
● Call up the menu for entering the edge guide position and enter the edge guide position
"3.0", see Chapter 9.07 Entering the edge guide position.
● Call up the seam depth input menu and enter the seam depth "3.0".
● Select first seam section.
● Call up the correction value input menu.
3.0
3.0
1
0
● Place the workpiece on the angle outline on the display and adjust the angle.
The correction value is calculated automatically from the adjusted angle.
● Conclude the input and take over the correction value.
● Switch on the automatic sewing stop at the end of the seam section function.
1.9
3.0
135
135
3
2.0
0.0
0
To Next Page
Loading...
