Installation and commissioning
8 - 4
8.02 Commissioning
● Check the machine, in particular the electrical leads and pneumatic connection tubes, for
any damage.
● Clean the machine thoroughly and oil it (see Chapter 10 Care and Maintenance).
● Have mechanics ensure that the machine’s motor can be operated with the available
electricity supply and that it is connected correctly to the junction box. If not, the machine
must not
be operated under any circumstances.
● The balance wheel must rotate towards the operator when the machine is running. If not,
have the motor connection changed by a mechanic.
● Connect the machine to the compressed air system. The pressure gauge must display a
pressure of approx. 6 bar. If not, adjust the pressure to this value (see Chapter 10.06
Checking / adjusting the air pressure).
8.03 Switching the machine on / off
● Switch the machine on or off (see Chapter 7.01 On/off switch).
● Carry out a test run.
8.01.06 Fitting the reel stand
● Fit the reel stand as shown in Fig. 8-06.
● Insert reel stand in the table-top hole and
fasten it with the included nuts.
Fig. 8 - 06
To Next Page
Loading...
Need help?
General
