Pfaff 294 - Thread Check Spring (on PFAFF 294 and PFAFF 1294 with -900;56)

Adjustment
11 - 19
7 mm
1
6
4
9
7
2
11.04.17 Thread check spring (on PFAFF 294 and PFAFF 1294 with -900/56)
Requirement
The motion of the thread check springs 1 and 6 should have ceased when the needle points
enter the material ( = approx. 7 mm spring stroke).
Fig. 11 - 17
● Turn screw 2 (screw 3) to adjust the tension of thread check spring 1.
● Turn retainer 4 (screw 5) in accordance with the requirement.
● Turn screw 7 (screw 8) to adjust the tension of thread check spring 6.
● Turn retainer 9 (screw 10) in accordance with the requirement.
Due to technical reasons, the length of the thread-check spring stroke can vary a
little in either direction.
3
810
5