11 - 3
Adjustment
11.04.02 Lengthwise positioning of the feed dog
Requirement
With the stitch length set at its longest the clearances behind and in front of the bottom
feed dog 5 to the needle plate cutout must be the same.
2
3
1
4
● Set the longest stitch length.
● Move the clamp piece 1 (screws 2) as far to the left as possible on the clamp surface 3
of the rock shaft. The left screw must still be on the clamp surface.
● Loosen screws 4.
● Move the bottom feed dog 5 in accordance with the requirement.
● Tighten screws 4.
Fig. 11 - 02
X
=
X
5
To Next Page
Loading...
