Operating Controls
20
F2 (setting aid for the edge trimmer)
O The corresponding function is switched on or off by pressing the key.
The edge knife moves to the trimming position in manual sewing when the function is
switched on.
F3
O After calling up the corresponding "PC" (piece counter) function, the piece counter is
reset by pressing this key, see chapter 10.03.03 Switching on the edge trimmer with a
time delay (waistband extension)
Start inhibitor
O The start inhibitor is switched on or off by pressing the key. The sewing or seam
sequence cannot be started when the function is switched on.
To Next Page
Loading...
