Maintenance and Care
65
These maintenance intervals are based on an average running time of a single
shift production shop. Shorter maintenance intervals are recommended for in-
creased running times.
12.02 Cleaning the machine
The required cleaning cycle for the machine depends on the following factors:
O Single or multi-shift operation
O Dust formation caused by the workpieces
Optimal cleaning instructions can therefore only be determined on a case-by-case basis.
Disconnect the machine from the electricity mains for all cleaning work by shut-
ting off the main switch or removing the mains plug! Risk of injury due to acci-
dental machine start-up!
The following tasks are recommended
during single shift operation to avoid
operational errors:
O Tilt machine backwards.
O Clean the hooks and hook area daily or
more often during continuous operation.
Return the machine to its up-
right position using both hands!
Danger of injury by crushing be-
tween the edge of the machine
and the table top.
12 Maintenance and Care
12.01 Maintenance intervals
Cleaning ........................................................daily, several times if in continuous operation
Clean the hook area ......................................daily, several times if in continuous operation
Check oil level ...................................................................................... daily, before start-up
Lubricate the bevel gears .................................................................................. once as year
Clean the blower air filter ................................................................................... as required
Check / set the air pressure ................................................................. daily, before start-up
Cleaning the maintenance unit air filter ............................................................... as needed
Fig. 12 - 01
To Next Page
Loading...
