LAN System Requirements
Configuring LAN Network Settings
2-2 Efficia CM Series Network Configuration Guide
• The Efficia Central receives the positive or negative ACK message from the server
and then returns the ACK message to the monitor.
LAN System Requirements
Your monitor and LAN must meet the following minimum requirements:
• Efficia software release A.01.
• Local Area Network using Ethernet TCP/IP IEEE 802.3.
• Network cables must be Cat 5 or better, RJ-45, unshielded twisted pair (no
crossover cables).
Warning To ensure patient electrical isolation, connect only to other equipment that provides
patient electrical isolation. Do not use shielded LAN cables.
• The network must be properly routed so that the destination server is reachable
from the monitor. To check connectivity from the monitor, see “Sending a Ping” on
page 6-2.
LAN Configuration Overview
To configure the network settings on the monitor, follow these steps:
For detailed information about configuration settings that are not described in this
document, see the Efficia CM Series Patient Monitors Installation and Configuration
Guide.
Obtain LAN Network Information
Obtain the following information from your network administrator. The information you
need to configure the monitor depends on your network configuration.
Destination Server
IP Address or Host Name:_________________________________________________
Destination Server Port: _________________________________________________
Encryption Key: _________________________________________________
Step See
1
Obtain information about your
current or planned network.
“Obtain LAN Network Information” on
page 2-2.
2
Configure the IP address of the
destination server.
“Configuring the Server IP Settings” on
page 2-3.
3
Configure the IP settings for the
monitor.
“Configuring the Monitor’s IP Address”
on page 2-5.
4
Connect to the LAN network. “Connecting to the LAN Network” on
page 2-5.
To Next Page
Loading...
