Philips Efficia CM Series - Configuring the Monitors IP Address

Configuring WLAN Network Settings
Efficia CM Series Network Configuration Guide 3-13
Configuring Security Settings
Configuring the Monitor’s IP Address
Note — The Monitor Name is used to register as the DNS hostname.
The default Monitor Name is the monitor’s serial number. It can be changed from both the
monitor display (select the monitor name at the bottom) or the General tab on the System
Menu
. After the monitor name is changed, it is used to register as hostname. If registration fails,
the monitor keeps the new name but the hostname is not identifiable in the network.
To configure IP address settings for the monitor:
4
Enter the IP address or the hostname (up to 50 characters) of the
destination server, and then select OK.
5
If necessary, change the optional settings, as described in “Configuring the
Server IP Settings” on page 3-11.
• Server Port
• Export Port to cfg File
• SSL
• NBP Pressure Units
• IBP Pressure Units
• Temperature Units
• CO2 Pressure Units
• SpHb Units (Masimo only)
• Height Units
• Weight Units
• CO2(Gas) Pressure Units
• AGT/N2O(Gas) Units
6
Select Apply to save your changes and return to the Admin tab on the
System Menu.
7
Proceed to the next section, “Configuring the Monitor’s IP Address” .
Step
Step
1
On the Admin tab in the System Menu, select the Wireless button.
The Available Wireless Networks menu appears.
2
Select the IP Address button.
The Wireless IP Address Menu appears.