Philips Efficia CM Series - Formatting the SD Card

Troubleshooting
Efficia CM Series Repair Guide 3-45
Formatting the SD Card
• LCD usage time
• Time zone
• AC line frequency
• RTC calibration data
• Country code
• Main board version, ID, and serial number
• Front end board version, ID, and serial number
• Usage and calibration data saved in the internal memory of each measurement
module
To clear all patient data:
Formatting the SD Card
If the Full Disclosure option is configured on the monitor, all Full Disclosure waveforms
are saved to an SD card. If a new or replacement SD card is used it must be formatted.
If the SD card becomes corrupted, it can be corrected by formatting it. Formatting the
SD card clears all of the Full Disclosure data stored on the card.
To format the SD card:
Step
1
Open the Maintenance options of the Diagnostics Menu. See “Accessing
the Diagnostics Menu and Maintenance Options” on page 2-8.
2
Select the Clear Data button.
A confirmation window appears.
3
Select the OK button.
The monitor clears the data and then restarts.
Step
1
Open the Maintenance options of the Diagnostics Menu. See “Accessing
the Diagnostics Menu and Maintenance Options” on page 2-8.
2
Select the SD Card button.
The SD Card menu appears and displays the SD Card Information,
including the card capacity and the used and available memory values.
3
Select the Format SD Card button.
The monitor restarts and the SD card is reformatted.
After the SD card is reformatted, the monitors restarts and opens to the
Main screen.