Philips Efficia CM Series - Removing the Chassis

Repairing the Monitor
Efficia CM Series Repair Guide 4-23
Removing the Chassis
Removing the Chassis
To remove the chassis:
4
Pull the SpO
2
board upward to separate it from the connector on the
front end board.
5
Disconnect the ribbon cable.
Connectors
Ribbon Cable
Step
1
Remove the rear case. See “Removing the Rear Case” on page 4-10.
2
Remove the front end assembly. See “Removing the Front End
Assembly” on page 4-20.
3
Remove the communications board. See “Removing the
Communications (I/O) Board” on page 4-15.