Philips Efficia CM Series - Removing the LCD Assembly

Repairing the Monitor
Efficia CM Series Repair Guide 4-29
Removing the LCD Assembly
Removing the LCD Assembly
Caution After you replace the LCD, you must reset the LCD Usage Hours. For more
information on resetting the LCD Usage Hours, see “Managing Component Usage
Parameters” on page 3-40.
Perform this procedure in a dust-free environment to avoid damage to the LCD
display.
To remove the LCD assembly:
Step
1
Remove the rear case. See “Removing the Rear Case” on page 4-10.
2
Remove the chassis. See “Removing the Chassis” on page 4-23.
3
Remove the main board. See “Replacing the Main Board” on page 4-27.
4
Use wire cutters to cut the plastic zip tie and remove it.
5
Remove the Torx T10 screws (torque: 0.8 Nm) that attach the LCD
assembly to the front panel.
6
If you are repairing a CM12, CM120, or CM150, remove the Torx T6 screws
(torque: 0.6 Nm) from the side of the LCD assembly.
7
Pull the LCD assembly away from the front panel.
Screws
Zip tie