Philips Efficia CM Series - Upgrading the Recorder Firmware

Repairing the Monitor
Efficia CM Series Repair Guide 4-9
Upgrading the Recorder Firmware
Upgrading the Recorder Firmware
To upgrade the recorder firmware:
5
Loosen (do not try to remove) the two Torx T10 screws (torque: 0.6 Nm)
holding the recorder to the monitor case.
6
Place your thumbs on either side of the recorder case and pull it straight
out of the assembly.
7
Disconnect the recorder cable from the main board, and remove the
recorder.
Screws
Cable
Step
1
Access the Diagnostics Menu. See “Accessing the Diagnostics Menu and
Maintenance Options” on page 2-8.
2
Insert the firmware upgrade USB flash drive into a USB port.