Philips Efficia CM Series - Replacing the Front Panel Assembly; Upgrading the Software

Replacing the Front Panel Assembly
Repairing the Monitor
4-30 Efficia CM Series Repair Guide
Replacing the Front Panel Assembly
To replace the front panel assembly:
Upgrading the Software
For information on upgrading the Efficia CM patient monitor software, refer to the
Efficia CM Series Patient Monitors Service Guide.
For information on upgrading the Efficia rack and module firmware, refer to the Efficia
Rack Service Guide.
Step
1
Remove the rear case. See “Removing the Rear Case” on page 4-10.
2
Remove the chassis. See “Removing the Chassis” on page 4-23.
3
Remove the wireless assembly. See “Replacing the Wireless Assembly”
on page 4-14.
4
Remove the main board. See “Replacing the Main Board” on page 4-27.
5
Remove the LCD assembly. See “Removing the LCD Assembly” on
page 4-29.