Philips Efficia CM Series - 4 Repairing the Monitor; Shutting down the Monitor; Disassembling the Monitor

Repairing the Monitor
Efficia CM Series Repair Guide 4-1
4
Repairing the Monitor
Shutting Down the Monitor
Perform a hard shutdown whenever you need to power down the monitor for
maintenance or repair. A hard shutdown ensures that all patient and system data is
saved in memory.
To initiate a hard shutdown on the monitor:
Disassembling the Monitor
This chapter contains the procedures for disassembling the monitor to replace
defective assemblies or components.
The monitor has three main assemblies:
• Rear case
• Chassis
• Front panel
Note — The Efficia CM120 monitor is shown below. Your monitor may be slightly
different.
Step
1
Do one of the following:
• Press and hold the On/Standby key for at least 7 seconds.
• Select the System button, and in the System Menu, on the General tab,
select the Shut Down button.
2
In the window that appears, select OK.
The monitor shuts down after saving the data.