Disassembling the Monitor
Repairing the Monitor
4-2 Efficia CM Series Repair Guide
For more information about replaceable parts, see Chapter 5, “Replacement Parts and
Assembly Drawings.”
Warning Before you open or disassemble the monitor, disconnect the AC power from the
monitor and remove the battery.
After any monitor repair, you must perform the recommended Performance and
Safety tests before you put the monitor into operation. Failure to perform these
tests can result in erroneous monitor readings. For more information about
performing safety and performance tests, see Chapter 2, “Performance Verification
Testing.”
If a repair or upgrade changes the functionality of the monitor, Philips recommends
that your facility establishes a protocol to train users about any changes before the
upgraded monitor is put back into service.
Caution Repairs should be made by qualified service personnel only.
Repairs should be made only with the recommended parts. Use of incorrect parts
can cause damage to the monitor or incorrect measurements.
Observe ESD (electrostatic discharge) precautions when disassembling the
monitor, working inside the monitor, and reassembling the monitor.
If the Gases module is installed, use caution when turning the water trap to prevent
injury by crushing or pressing fingers against the exhaust connector of the module.
Do not dispose of this product (or any parts of it) in industrial or domestic waste.
The system may contain hazardous substances that can cause serious
environmental pollution. The system also contains privacy sensitive information.
Philips recommends that you contact your Philips Service Organization before
disposing of this product.
To avoid contaminating or infecting personnel, the environment or other
equipment, disinfect and decontaminate the monitor before disposing of it in
accordance with your country's laws. For more information, see the resources listed
below.
Philips Healthcare gives support for:
• Recovery of reusable parts.
Rear case assembly
Chassis assembly
Front panel assembly
To Next Page
Loading...
