Philips Efficia CM Series - Replacing a Fuse; Replacing the Recorder

Replacing a Fuse
Repairing the Monitor
4-8 Efficia CM Series Repair Guide
Replacing a Fuse
To replace a fuse in the AC power connector:
Replacing the Recorder
To replace the recorder:
Step
1
Shut down the monitor. See “Shutting Down the Monitor” on page 4-1.
2
Remove the AC power cord from the rear of the monitor.
3
Remove the battery from the monitor (see “Replacing the Battery” on
page 4-5).
4
Use needle-nose pliers to pull the fuse holder out of the AC power
connector.
5
Replace the fuse or fuses, and then push the fuse holder back into the
power connector until it snaps into place.
Step
1
Shut down the monitor. See “Shutting Down the Monitor” on page 4-1.
2
Remove the AC power cord from the rear of the monitor.
3
Remove the battery from the monitor (see “Replacing the Battery” on
page 4-5).
4
Open the recorder door on the rear case assembly and remove the
paper roll.