Replacing the Wireless Assembly
Repairing the Monitor
4-14 Efficia CM Series Repair Guide
Replacing the Wireless Assembly
To replace the wireless assembly:
Step
1
Remove the rear case. See “Removing the Rear Case” on page 4-10.
2
Remove the three Phillips screws (torque: 0.1 Nm) from the wireless
board and remove it.
Caution
Use caution when removing the assembly. The antenna connection to
the wireless board is fragile. Do not attempt to disconnect the
antenna and remove the assembly in one piece.
3
Lift the antenna board out of the front panel.
Antenna board
Screws
Antenna
To Next Page
Loading...
