3. Connect the printer’s power cord into the back of the printer, and plug the other end into
an appropriate power source (see “Warnings” on page 16).
4. Plug the system's power cord into an appropriate power source.
5. Turn on the printer, and then turn on the system. The system installs the printer drivers
automatically.
6. After the system installs the new printer drivers, restart the system.
Configuring Local Printers
You can add a local printer to the system and then, in the setups, associate it with either a
touch screen control or the Acquire 1 or Acquire 2 control. You can print only to a printer that
has been selected. You can also change other printing parameters.
WARNING
Multi-image prints made on small-size paper are intended only for reference and should not
be used for diagnostic purposes. Text annotation and scaling markers may not be visible on
such prints.
NOTE
Before adding a local printer, connect the printer to the ultrasound system.
1. Touch Utilities.
2. On the System tab, touch Setups.
3. Click Acquisition/Capture.
4. Click the Archive/Printer tab.
5. To assign a printer to the Acquire 1 or the Acquire 2 control, do the following:
a. From the Acquisition Type list, select a type.
b. Select the printer that you want to use.
6. To assign a printer to a touch screen control, do the following:
a. Under Select a Touch Screen Button, select the name of the control that you want to
assign.
b. In Destination(s) for the Button, select a printer.
7. To exit the setups, touch Close.
Preparing the System
Connecting Devices
104 EPIQ 7 User Manual 4535 617 25341
To Next Page
