5. Under Procedure Setup, do one of the following:
• To create a new procedure, click Create New.
• To modify an existing procedure or create a new procedure from an existing
procedure, select an item from the Procedure list, and then click Modify.
• To delete an existing procedure, select an item from the Procedure list, and then click
Delete.
6. For new or modified procedures, complete the following:
• Procedure Name: Enter the name of a new procedure, or modify the name of an
existing procedure.
• Study Description: Enter the type of study for which the new or modified procedure is
intended.
• Gender: Select the gender of the patient.
• Study Description: Enter a brief, meaningful description of the study in which the new
or modified procedure is used.
• Transducer: Select a transducer from a list of all of the transducers that are supported
by the system.
• Preset: Select a preset from a list of all of the presets that are available for the
selected transducer.
7. Click Save and then click Close.
To use the new custom procedure, see “Selecting a Custom Procedure” on page 153.
Selecting a Custom Procedure
Custom procedures are available from the Patient Data form.
NOTE
Custom procedures are linked to specific transducers. If the transducer required for the
procedure is unconnected, procedures that use it do not appear in the Procedure menu.
1. Touch Patient.
2. In the Clinical Procedure section of the Patient Data form, select the custom procedure
from the Procedure menu.
3. Click Done.
4. Start the exam.
Custom Procedures
Customizing the System
EPIQ 7 User Manual 4535 617 25341 153
To Next Page
Loading...
