NOTE
If battery power is unavailable, or if the battery charge level is critically low, as indicated by the
(low battery power) icon, connect the system power cord to a wall outlet.
NOTE
The system must be connected to a wall outlet to be used for imaging.
1. If you are turning off the system, first close all dialog boxes by clicking Close or Done
2. Do one of the following:
• When the system is off, press the (On/Off) control to turn it on.
• When the system is on, press the (On/Off) control to turn it off. A confirmation
message appears briefly on the display immediately before the system turns off.
3. If the system does not turn off after 90 seconds (or 3 minutes if DICOM activity is
occurring), press and hold the
(On/Off) control for 7 to 10 seconds to force the system
to turn off.
4. To break the connection from the main power supply, remove the ultrasound system plug
from the wall outlet.
Setting the System Time and Date
The system includes a clock/calendar function, which maintains accurate time and date even
when the system is turned off and disconnected from power. The system uses the clock/
calendar function to display the time and date on the imaging display, and to provide a time
stamp on patient studies and acquired images. The system automatically adjusts the date for
leap years but does not automatically set the time zone or update for daylight saving time.
NOTE
The system time and date cannot be set when a study is active. It is recommended that you
check the system time and date periodically before a study, and set the correct time and date,
if necessary.
Using the System
Setting the System Time and Date
114 EPIQ 7 User Manual 4535 617 25341
To Next Page
Loading...
