+---------------------------------------------------------------------------+
¦ FLASH Programming Monitor V2.1 (C) 1999 ¦
¦ COM1 File: <NONE> ¦
¦ Status: FLASH app. ¦
+---------------------------------------------------------------------------+
P: Program FLASH T: Terminal
X: eXit ?: Display menu
The Guidance will show a special screen, indicating the KB that already have be downloaded.
When the download procedure is finished (after about 10 minutes) the following message appears:
‘HEX programming done’.
- Now switch off the unit, wait a few seconds and restart the unit. The unit will now indicate the
new software version in the startup screen.
- When the device is passing the selftest with success the device can be used normally.
10.4 Troubleshooting.
If the PC cannot connect to the unit, check whether the interface cable is properly connected and
check whether the right COM port has been choosen.
Try the other batch file (Flash1.bat or Flash2.bat) to see if this solves the problem.
In case of any error (most of the time this will be error 601), switch off the Guidance and repeat the
download procedure.
Phyaction Guidance E/C – service manual version 0.5 Page 41
To Next Page
Loading...