System
wlan
18
3.10
By pressing the OK button, the two navigation arrows next to the function
key eld turn blue and the functions to be changed can now be selected via
the keypad.
If functions other than those shown are to be changed, you can use the "up"
or "down" keys to scroll line by line to the desired area. The solid navigation
arrow indicates the direction in which you can scroll.
3.10
Swapping two function keys is achieved by rst highlighting one of the two
function keys using the keypad (eld turns blue). The second function to be
exchanged is then selected with the keypad.
In the example shown, it would be the function keys F2 and F3, if the key F3
were now pressed.
3.10
To change the symbol/icon of a function key, rst highlight it using the
keypad and then press the OK button.
A total selection of 46 function symbols will now appear which you can scroll
through using the “right” and “left” navigation keys.
3.10
Once you reach the desired symbol, you can choose whether the function
will be a one-touch momentary function or a function that stays in operation
as long as the symbol is highlighted. To assign a momentary key function
(m), use the "up" or "down" navigation keys. A momentary function means
that the function is only switched on for as long as the function key is
pressed.
These settings are then saved by pressing the OK button.
3.10
In the example shown, F3 horn function key has been changed to an "Up /
Down" symbol.
Once all the entries have been made for this locomotive, press the "Back "
button on your throttle ...
To Next Page
Loading...
