wlan
23
There is no need to enter the type, since the factory setting "Simple"
is used automatically here.
Enter the rst address for the red/green toggle, followed by the se-
cond address to toggle yellow on/o. Then enter the activation time
in 100ms steps.
In the following steps, enter the switching directions red/green for the signal aspects shown and then
save the data set.
NOTE: For technical reasons, the nal display order depends on the available open eld locations.
This means that when accessories have been deleted, the next newly created data set is automatically
saved in the eld location that was just deleted.
The display of the new article does not necessarily reach the position that
was displayed when the empty eld was selected.
To Next Page
Loading...
