EasyManuals Logo

Pilz PNOZ s50 User Manual

Pilz PNOZ s50
69 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
Operation
OperatingManualPNOZs50
1002194EN02
50
Cat. No. Errormessage Description Remedy
0 2 EnterStop Systemisin"STOP"state Purelyforinformation
0 3 EnterRun Systemisin"RUN"state Purelyforinformation
1 0 ACKIOFault The"IOFault"errorhasbeenre
setwiththeinputsY10/Y11and/
orY20/Y21(1/0pulseedge)
Purelyforinformation
4 0 CopyConfig Theconfigurationhasbeen
loadedfromthechipcardtothe
device.
Purelyforinformation
4 1 CopyConfig Thedevicehassavedtheconfig
urationtothechipcard.
Purelyforinformation
4 2 MissingCard Thereisnochipcardinthecard
slot.
Insertavalidchipcardintothe
cardslot
4 3 InvalidCard Thedataonthechipcardisin
valid
Checkchipcard
Insertavalidchipcardintothe
cardslot
4 4 Mems.Differ Thedataonthechipcarddiffers
fromthedatainthedevice
Useachipcardcontainingthe
deviceconfiguration
Writethedeviceconfigurationto
chipcard
4 5 CardRemoved Thechipcardhasbeenremoved
duringoperation
Insertavalidchipcardintothe
cardslot
4 6 UnknownCard Thechipcarddoesnotcontain
devicedataforthePNOZs50
Insertavalidchipcardintothe
cardslot
5 0 WrongPin Thepasswordisinvalid Enteravalidpassword
5 1 PinChanged Thepasswordhasbeen
changed
Purelyforinformation
5 2 Count.atMax Theeventcounterhasreached
themaximumvalue99999999.
Theeventcounterisnotreset
automatically.
Reseteventcounter
5 3 Chan.Differ Errorinthedevice'sparameter
settings
Checkparametersettings
6 0 SupplyNOK SupplyvoltageB1/B2tothe
powercircuitsisoutsidetheper
mittedrange.
Parameter1:
0x000000002
Checkthesupplyvoltage
6 1 SupplyOK SupplyvoltageB1/B2tothe
powercircuitsisonceagain
withinthepermittedrange.
Parameter1:
0x000000002
Purelyforinformation
7 0 ResetConfig Thedevicehasbeenresettoits
defaultsettings.
Purelyforinformation

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pilz PNOZ s50 and is the answer not in the manual?

Pilz PNOZ s50 Specifications

General IconGeneral
BrandPilz
ModelPNOZ s50
CategoryRelays
LanguageEnglish

Related product manuals