Function description
Operating Manual PSENmlock mini, PSEN mlm 1 sa 1.1/2.1/2.2
1005802-EN-02-Draft
| 26
NOTICE
The auxiliary release does not represent a safety function.
The operator is responsible for using an appropriate auxiliary release, de-
pending on the specific application. A hazard assessment can be carried
out as an option, and specifications from the product standard must be ad-
hered to.
The functionality of the auxiliary release should be checked regularly.
Fig.: Auxiliary release
Legend
[1] Auxiliary release screw, hexagon socket with wrench size 4 (SW4)
[2] Marked area for locking varnish
(supplied without locking varnish)
Operating principle
1. Using an Allen key (SW4), rotate the auxiliary release screw [1] as far as it will go in the
direction of the arrow (max. 230°). The guard locking pin is displaced and the bolt is re-
leased.
The safety gate to the danger zone can be opened.
5.10.1 Recommissioning
Recommission the safety switch
1. Using an Allen key (SW4), rotate the auxiliary release screw [1] (see diagram [
25])
as far as it will go in the opposite direction to the arrow (max. 230°).
2. Use varnish to seal the marked area/indent [2] (see diagram [
25]).
3. Carry out a function test on the safety switch and actuator. The safety function may only
be checked by qualified personnel.
INFORMATION
If the auxiliary release screw is not turned back correctly after use, guard
locking cannot be activated/deactivated.
To Next Page
Loading...
