70
Tiltable Plasma Display Wall-Mount Hardware: PDK-5006
4) Adjusting the angle
This mounting can be tilted 25 degrees, without set increments.
The work should be done by two people.
1 Loosen screw c on the left and right vertical frames.
2 While sliding the arm down, push the display to the desired angle.
3 Once the desired angle is reached, tighten screw c on the left and right frames.
When mounting the display flush or parallel to the wall,
secure the movable and fixed portions of the mount frame
by tightening the screws a, as shown. This prevents
accidental tilting of the display. You must also tighten the
left and right c screws.
c
a
After mounting the unit at an angle, an additional
reinforcement measure can be taken by attaching an
appropriate wire and a flat bar using screws a.
When the angle is set to less than 5°, please secure using
wires or a flat bar etc.
Measuring the opening distance X enables approximate
angle values to be determined.
X Angle
181 mm 5°
236 mm 10°
290 mm 15°
341 mm 20°
Wire, flat bar
X
To Next Page
Loading...
Need help?
General