Pipistrel Sinus - Page 145

K i t M a n u a l f o r P i p i s t r e l S i n u s a n d V i r u s A i r c r a f t
 Prepare a 520mm rubber hose and run it from the oil cooler, under the brace with the
oblong hole and towards the cylinder head 1. Use a 18mm-diameter hose clamp. Leave it
there for future use.
 Cover the end of the cooling system pipe and turn the motor upside down.
 Remove the two large support brackets and also the water pump.
http://www.pipistrel.si © Pipistrel Release March 2009 © Page 145 of 267