Pipistrel Sinus - Page 144

K i t M a n u a l f o r P i p i s t r e l S i n u s a n d V i r u s A i r c r a f t
 Now that you've mounted the oil cooler you can also fit the propeller pitch-correction
lever with the provided spring and greased up washer at the end.
 Above the 2
nd
and 4
th
cylinder heads there's a couple of mounting clips. Fit the one
shown in the photos below with the provided cable holder.
 Then fit the cable holder with the provided cable guide. Apply blue Loctite 243.
 Heat the end of a 60mm plastic hose and fit it to the end of the cable guide.
 Fit the throttle/choke cable plate.
http://www.pipistrel.si © Pipistrel Release March 2009 © Page 144 of 267