Collect the throttle/choke cables. You should have received one long one and three
slightly longer ones.
Start with the longer one. This cable is the throttle cable for the left carburetor, because
it is positioned a little further back from the carburetor control bracket than the right
carburetor. Slide it through the upper fitting near the carburetor head and fix it to the
throttle lever using the locking screw.
Crimp an aluminum cable swage to the end of the cable and trim any excess cable.
Attach the choke cables in a similar fashion.
Use heat shrink tubing and a heat gun to secure the cables in the fittings.
http://www.pipistrel.si © Pipistrel Release March 2009 © Page 154 of 267