Pipistrel Sinus - Page 155

K i t M a n u a l f o r P i p i s t r e l S i n u s a n d V i r u s A i r c r a f t
 Feed all the carburetor cables to the upper end of the carburetor cable control bracket.
Slide heat shrink tubing on each cable. Ensure that you have positioned them correctly.
The picture below shows how both choke cables are on the left hand side (when looking
towards the propeller end) and both throttle cables are on the right.
 From the upper edge of the carburetor cable control bracket, measure 50 mm and trim all
four cables.
 Take both throttle cables and fit them into the brace holder. Fix them in place using the
screw and then permanently fix them by soldering.
NOTE: For this step, it is extremely important that the cable housings are always placed firmly
in the fittings and that there is no slack in the cables.
http://www.pipistrel.si © Pipistrel Release March 2009 © Page 155 of 267