Pipistrel Sinus - Page 208

K i t M a n u a l f o r P i p i s t r e l S i n u s a n d V i r u s A i r c r a f t
 Cut out the template provided (Appendix 15) and align it nicely with the wing profile and
placement peg found at the wing root.
 Then mark the center point of the holes needed for the fuel level guage.
 Drill a 2 mm hole first and be sure to use a vacuum cleaner because you don't want any
debris to get into the fuel tank. Then sand the area for epoxy.
 Now drill out the holes to 5.5 mm and countersink the holes to accept the fuel fittings.
Mix up some epoxy and glue the fuel fittings in place. Hold in place with some strong
tape and leave them overnight. Wipe off any extra epoxy before it goes hard.
http://www.pipistrel.si © Pipistrel Release March 2009 © Page 208 of 267