Pipistrel Sinus - Page 209

K i t M a n u a l f o r P i p i s t r e l S i n u s a n d V i r u s A i r c r a f t
Continue with wing setup:
 Heat up and fit the fuel guage tube. Secure it with cable ties at both ends to stop leaks.
 Then fit a plugged line over the breather outlet and create a vacuum in the tank using a
pressure gauge. Allow it to sit for 4 hours and make sure there are no leaks in the fuel
tank before it’s filled with fuel.
http://www.pipistrel.si © Pipistrel Release March 2009 © Page 209 of 267