Pipistrel Sinus - Page 210

K i t M a n u a l f o r P i p i s t r e l S i n u s a n d V i r u s A i r c r a f t
 To find the fuel tank cap locations look for a small indent in the wing and use the Dremel
to grind it out. Make sure to use the paper fitting and not the metal fittings on the
Dremel. Only go about 3 mm down or you may damage the thread of the cap fitting.
 Open up the hole to meet the edge of the cap fitting and always use a vacuum to keep
dust from going into the tank. When finished fit the cap and the breather fitting, use
epoxy on the breather fitting and rotate the end to be at 90 degrees to the leading edge
and with the vent holes to the rear.
http://www.pipistrel.si © Pipistrel Release March 2009 © Page 210 of 267