Pipistrel Sinus - Page 36

K i t M a n u a l f o r P i p i s t r e l S i n u s a n d V i r u s A i r c r a f t
 Drill the 4 holes in the base and then drill and bolt the 4 holes on the seat back using red
Loctite 262. Note that on some aircraft, especially virus, you will have to grind some
material from the middle floor tunnel, or from the middle support beam to get it all to fit,
as it sometimes get made too thick. Remember to drill carefully, so that you don't hit the
elevator pushrods.
http://www.pipistrel.si © Pipistrel Release March 2009 © Page 36 of 267