Pipistrel Sinus User Manual

K i t M a n u a l f o r P i p i s t r e l S i n u s a n d V i r u s A i r c r a f t
 Mask the elevator pushrod with masking tape to keep out dust and debris from the
pushrod bearings during the early fuselage preparation phases.
 Sand the cockpit openings smooth to remove the sharp edges from manufacture
 Sand the windscreen edge to ensure a good fit of the Lexan windscreen, paying particular
attention to the section marked with ovals in the photos below. The key is to make sure
the edges around the windscreen are smooth and not sharp.
http://www.pipistrel.si © Pipistrel Release March 2009 © Page 6 of 267

Pipistrel Sinus Specifications

General

Manufacturer	Pipistrel
Seats	2
Rate of climb	5.5 m/s (1, 080 ft/min)
Ballistic parachute rescue system	Optional
Engine	Rotax 912
Type	Motor glider