Pipistrel Sinus - Page 60

K i t M a n u a l f o r P i p i s t r e l S i n u s a n d V i r u s A i r c r a f t
 Put cable ties over the rudder cables where they come out of the floor and apply Loctite
406 or superglue to keep them firmly in place and stop the cable ties from coming off.
 When the glue has dried, pull the rudder cable outers firmly from the rear to remove any
slack, trim off the excess cable outer in the cockpit leaving about 1 cm exposed and in
the rear cut off the tubes to about 75mm long behind the first bulkhead.
http://www.pipistrel.si © Pipistrel Release March 2009 © Page 60 of 267