User Manual of VDR-301N
The following table describes the parameters:
Field Description
Enabled/Disabled
Click the radio button to enable/disable the interface group feature. If
disabled, all interfaces belong to the default group.
Interface groups
To manipulate a mapping group:
1. Select a group from the table.
2. Select interfaces from the available/grouped interface list and add it
to the grouped/available interface list using the arrow buttons to
manipulate the required mapping of the ports.
5.4.6 Others
Choose Advance > Others and the page shown in the following figure appears. The page displayed contains
Bridge Setting, Client Limit, Tunnel, Telnet and Others.
5.4.6.1 Bridge Setting
Choose Advance > Others > Bridge Setting and the page shown in the following figure appears. This page is
used to configure the bridge parameters. You can change the settings or view some information on the bridge
and its attached ports.
Figure 5-57 Bridge Setting
The following table describes the parameters:
Field Description
Aging Time
If the host is idle for 300 seconds (default value), its entry is deleted
from the bridge table.
802.1d Spanning Tree
You can select Disable or Enable.
Select Enable to provide path redundancy while preventing undesirable
loops in your network.
Show MACs Click it to show a list of the learned MAC addresses for the bridge.
To Next Page
Loading...
