Planet XGS3-24042 - Lldp Function Configuration Task Sequence

11-2
11.2 LLDP Function Configuration Task Sequence
1. Globally enable LLDP function
2. Configure the port-based LLDP function switch
3. Configure the operating state of port LLDP
4. Configure the intervals of LLDP updating messages
5. Configure the aging time multiplier of LLDP messages
6. Configure the sending delay of updating messages
7. Configure the intervals of sending Trap messages
8. Configure to enable the Trap function of the port
9. Configure the optional information-sending attribute of the port
10. Configure the size of space to store Remote Table of the port
11. Configure the type of operation when the Remote Table of the port is full
12. Display and debug the relative information of LLDP
1. Globally enable LLDP function
Command
Explanation
Global Mode
lldp enable
lldp disable
Globally enable or disable LLDP function.
2. Configure the port-base LLDP function switch
Command
Explanation
Port Mode
lldp enable
lldp disable
Configure the port-
base LLDP function
switch.
3. Configure the operating state of port LLDP
Command
Explanation
Port Mode
lldp mode (send|receive|both|disable)
Configure the operating state of port
LLDP.
4. Configure the intervals of LLDP updating messages
Command
Explanation
Global Mode
lldp tx-interval <integer>
no lldp tx-interval
Configure the intervals of LLDP updating
messages as the specified value or
default value.
5. Configure the aging time multiplier of LLDP messages