Planet XGS3-24042 - Vrrpv3 Typical Examples

65-5
( 2 ) Configure VRRPv3 priority
Command
Explanation
VRRPv3 Protocol Mode
priority < priority >
Configure VRRPv3 priority.
( 3 ) Configure the VRRPv3 advertisement interval
Command
Explanation
VRRPv3 Protocol Mode
advertisement-interval <time>
Configure the VRRPv3 advertisement
interval (in cent seconds).
(4 ) Configure the monitor interface of VRRPv3
Command
Explanation
VRRPv3 Protocol Mode
circuit-failover {vlan <ID>| IFNAME}
<value_reduced>
no circuit-failover
Configure the monitor interface of VRRPv3,
the no operation of this command will delete
the monitor interface.
65.3 VRRPv3 Typical Examples
Figure
65-2 VRRPv3 Typical Network Topology
As shown in graph, switch A and switch B are backups to each other, switch A is the master of backup group 1
and a backup of backup group 2. Switch B is the master of backup group 2 and a Backup of backup group 1.
The IPv6 addresses of switch A and switch B are “IPv6_A” and “IPv6_ B” respectively (it is recommended that