Planet XGS3-24042 - MLD Typical Application

49-26
1）Configure interval time for MLD to send query messages
2）Configure the maximum response time of MLD query
3）Configure the overtime of MLD query
Command
Explanation
Port Configuration Mode
ipv6 mld query-interval <time_val>
no ipv6 mld query-interval
Configure the interval of MLD query messages
sent periodically; the NO operation of this
command restores the default value.
ipv6 mld query-max-response-time
<time_val>
no ipv6 mld
query-max-response-time
Configure the maximum response time of the
interface for MLD query; the NO operation of this
command restores the default value.
ipv6 mld query-timeout <time_val>
no ipv6 mld query-timeout
Configure the overtime of the interface for MLD
query; the NO operation of this command
restores the default value.
3. Shut down MLD Protocol
Command
Explanation
Port Configuration Mode
no ipv6 pim dense-mode | no ipv6
pim sparse-mode | no ipv6 pim
multicast-routing (Global Mode)
Shut down MLD Protocol
49.6.3 MLD Typical Application
As shown in the following figure, add the Ethernet interfaces of Switch A and Switch B to corresponding vlan,
and start PIM6 on each vlan interface.
Figure 49-5 Network Topology Diagram
The configuration procedure for SwitchA and SwitchB is as below:
SwitchB
Vlan 1
Vlan 1
Vlan 2
S
witch
A