Planet XGS3-24042 - Mbgp4+ Examples

41-2
3. Configure redistribution of OSPFv3 routing to MBGP4+
(1) Enable redistribution of OSPFv3 routing to MBGP4+
Command
Explanation
Router IPv6 BGP Configuration Mode
redistribute ospf [<process-tag>]
[route-map<word>]
no redistribute ospf
[<process-tag>]
To enable or disable redistribution of OSPFv3
routing to MBGP4+.
(2) Display and debug the information about configuration of redistribution of OSPFv3 routing to MBGP4+
Command
Explanation
Admin Mode and Configuration Mode
show ipv6 bgp redistribute
To display configuration information about
MBGP4+ routing which is redistributed from
other routing protocols.
Admin Mode
debug ipv6 bgp redistribute
message send
no debug ipv6 bgp redistribute
message send
debug ipv6 bgp redistribute route
receive
no debug ipv6 bgp redistribute
route receive
To enable or disable debugging messages sent
by MBGP4+ for redistribution of OSPFv3
routing.
To enable or disable debugging messages
received from NSM.
41.3 MBGP4+ Examples
SwitchB, SwitchC and SwitchD are in AS200, SwitchA is in AS100. SwitchA and SwitchB share the same
network segment. SwitchB and SwitchD are not connected physically.
Figure 41-1 BGP Network Topological Map
AS100
AS200
vlan1:2001::1
vlan1:2001::2
vlan1:2003::4
vlan2:2003::3
vlan1:2002::3
vlan2:2002::2
SwitchA
SwitchB
SwitchD
SwitchC