Planet XGS3-24042 - Pppoe Intermediate Agent Troubleshooting

61-16
Typical configuration (2) in the following:
Step1: Switch enables global PPPoE IA function, MAC as 0a0b0c0d0e0f.
Switch(config)#pppoe intermediate-agent
Step2: Configure port ethernet1/0/1 which connect server as trust port, and configure vendor tag strip
function.
Switch(config-if-ethernet1/0/1)#pppoe intermediate-agent trust
Switch(config-if-ethernet1/0/1)#pppoe intermediate-agent vendor-tag strip
Step3: Port ethernet1/0/2 of vlan1 and port ethernet1/0/3 of vlan 1234 enable PPPoE IA function of port.
Switch(config-if-ethernet1/0/2)#pppoe intermediate-agent
Switch(config-if-ethernet1/0/3)#pppoe intermediate-agent
Step4: Configure pppoe intermediate-agent access-node-id as abcd.
Switch(config)#pppoe intermediate-agent access-node-id abcd
Step5: Configure pppoe intermediate-agent identifier-string as “efgh”, combo mode as spv, delimiter of Slot ID
and Port ID as “#”, delimiter of Port ID and Vlan ID as “/”.
Switch(config)#pppoe intermediate-agent identifier-string efgh option spv delimiter # delimiter /
Step6: Configure circuit-id value as bbbb on port ethernet1/0/2.
Switch(config-if-ethernet1/0/2)#pppoe intermediate-agent circuit-id bbbb
Step7: Configure remote-id as xyz on ethernet1/0/3.
Switch(config-if-ethernet1/0/3)#pppoe intermediate-agent remote-id xyz
circuit-id value is ”bbbb”, remote-id value is ”0a0b0c0d0e0f” for the added vendor tag of port ethernet1/0/2.
circuit-id value is ”efgh eth 01#003/1234”, remote-id value is ”xyz” for the added vendor tag of port
ethernet1/0/3.
61.4 PPPoE Intermediate Agent Troubleshooting
 Only switch enables global PPPoE intermediate agent firstly, this function can be run on port.
 Configure a trust port at least, and this port can connect to server.
 vendor tag strip function must be configured by trust port.
 Circuit-id override priority is: pppoe intermediate-agent circuit-id < pppoe intermediate-agent
identifier-string option delimiter < pppoe intermediate-agent access-node-id.