Planet XGS3-24042 User Manual

48-34
48.7.2 DVMRP Configuration Task List
1． Globally enable and disable DVMRP (Required)
2． Configure Enable and Disable DVMRP Protocol at the interface (Required)
3． Configure DVMRP Sub-parameters (Optional)
Configure DVMRP interface parameters
1) Configure the delay of transmitting report message on DVMRP interface and the message number
each time it transmits
2) Configure metric value of DVMRP interface
3) Configure if DVMRP is able to set up neighbors with DVMRP routers which can not Prune/Graft
4． Configure DVMRP tunnel
1. Globally enable DVMRP Protocol
The basic configuration to function DVMRP routing protocol on XGS3 series Layer 3 switch is very simple.
Firstly it is required to turn on DVMRP switch globally.
Command
Explanation
Global Mode
[no] ip dvmrp multicast-routing
Globally enable DVMRP Protocol, the “
no ip
dvmrp multicast-routing
” command disables
DVMRP Protocol globally. (Required)
2. Enable DVMRP Protocol on the interface
The basic configuration to function DVMRP routing protocol on XGS3 series Layer 3 switch is very simple.
After globally enabling DVMRP Protocol, it is required to turn on DVMRP switch under corresponding
interface.
Command
Explanation
Interface Configuration Mode
ip dvmrp
no ip dvmrp
Enable DVMRP Protocol on the interface, the
“no ip dvmrp
” command disables DVMRP
Protocol on the interface.
3. Configure DVMRP Sub-parameters
（1）Configure DVMRP Interface Parameters
1) Configure the delay of transmitting report message on DVMRP interface and the message number
each time it transmits
2) Configure metric value of DVMRP interface
3) Configure if DVMRP is able to set up neighbors with DVMRP routers which can not Prune/Graft
Command
Explanation
Interface Configuration Mode

Planet XGS3-24042 Specifications

General

Brand	Planet
Model	XGS3-24042
Category	Switch
Language	English